[Rapid Vanguard] Tesla Spikes

Photo Oct 18, 12 55 46 AM
These parts will be used to make the coil for each spike.
Photo Oct 18, 12 56 04 AM
Slot the 2 parts from the previous step together to make a coil.
Photo Oct 18, 12 55 07 AM
Set aside these parts in this order.
Photo Oct 18, 12 56 44 AM
Take the parts from the previous step and slot them down over the long peg at the bottom of the coil starting with the smallest and going to the biggest. There are only 3 types, but you will use 1 small discs, 2 medium discs and 2 large slotted discs.
Photo Oct 18, 12 57 00 AM
Slot the whole thing into the base plate. If any of the tab protrudes from the bottom, sand or cut it away.
Photo Oct 18, 12 57 18 AM
Gather 6 fins as shown above.
Photo Oct 18, 12 57 39 AM
Insert fins into the slots around the bottom of the coil.
Photo Oct 18, 12 58 36 AM
Glue the acrylic sphere into the top of the coil and the Tesla spike is complete.

Leave a Reply

Your email address will not be published. Required fields are marked *


© 2012 - 2017 Death Ray Designs LLC.  All Rights Reserved.