Odinheim Hex Augment


Gather these parts

Glue The hook rails in the slots closes to the middle of the panel as shown

Glue triangular struts in place with the detail facing out as shown

Glue other rails in the slots on the outside as shown with the details facing out

Gather these parts

Glue the larger frame onto the non-detailed side of the backer plate

Glue the hex backer onto the hanger plate and struts

locate the hex plastic sheet

Place smaller frame over the hex sheet and trace the outline with a pencil

With a razor score the outline you traced in the previous step in the center of the line between hexes as shown.

Flex the plastic along the score line and it should snap out fairly easily

Flip the hex plastic so that the convex parts are up and glue the smaller frame you used to trace previously on top

Glue the frame with the plastic hexes into the frame on the backer plate

You’re all done!

Prime with Rust-o-leum Profesional Enamel flat black and paint as normal with hobby paints.


© 2012 - 2017 Death Ray Designs LLC.  All Rights Reserved.