Odinheim Power Substation


Gather these parts

Glue fins into the plate as shown

Find the two side panels and hatch plate. Keep in mind that there are two different (mirrored right and left) versions. Some sets include both. Pay close attention to parts in the photos to ensure you don’t mix right and left parts.

Glue the hatch panel into the tops of the side plates. Slide the hook over and rotate into the slot.

Gather these parts

Glue the back plate on the previous assembly as shown

Slot the fin plate into the holes in the hatch plate as shown

Slot the rectangular in the photo above into the inside of the currently assembled part as shown. Your plate may or may not have slots in the middle.

Glue the front plate in so that the fin plate slots into the small square slots at the top

Glue the front panel on as shown

Gather these parts

Glue the rail in place as shown on the side with one slot

Glue the center rail in the central slot as shown on the side with three slot

Glue the detail plate slotted around the rail placed in the previous step

Glue the detail plate slotted around the rail placed in the previous step

Flip the assembly over apply the other detail plate as shown

Glue rails down the front side as shown

Glue rails down the front side as shown

Gather these parts

Glue the top and bottom racks in as shown

Glue the two small connectors onto the bottom rack

Glue the keyboard onto the two small connectors from the previous step

Glue the Center screen and any 2 of the small screens in the gaps in the middle rack

Glue the 2 hangers into the slots in the top rack as shown

Glue the two remaining small screens into the hangers from the previous step

Find the top and bottom base plates

Glue the assembly to the top plate as shown with the pegs going through the slots in the plate

Glue the assembly and top plate to the bottom base plate as shown with the pegs going through the slots in that plate as well

Glue the mounting ring onto the back as shown

Glue resin power pack into the space in the previous part.  You may wish to paint separately and glue in afterwards.


Thanks!


© 2022 Death Ray Designs LLC.  All Rights Reserved.