Warp Strider Block Instructions


Locate the top plate

Gather these parts

Glue 3 walls into the bottom of the top plate

Glue the corner column plates into the slots on 2 corners as shown

Gather these pieces

Glue the “C” shaped pieces into the slots as shown

Glue one of the half-base pieces onto the parts from the previous steps as shown

Repeat the steps to get the other side up to the same point

Gather these parts

Glue those parts into the notches around the perimeter

Gather all of these parts

Glue each one into the slots on the walls

Gather 12 of each of these parts

Slot each of the pegs into the slots around the corners of the block and then glue the ring around them

You’re all done!

Prime with Rust-o-leum Profesional Enamel flat black and paint as normal with hobby paints.


Thanks!


© 2022 Death Ray Designs LLC.  All Rights Reserved.